Multifamily HOMES Project

Not started Deny Assign Send back for more information

182 Housing Program Court, Madison 53703 · Whole multifamily building, 5 or more homes · 5 of 5 units occupied · Project code PRJ-3JL3-A732 · Submitted on the customer portal

Assigned to: Unassigned

Reservation review

0 of 31 checks ticked. Press Approve at the top to go through them.

What the reports say

The portal checks the procedure's thresholds from these, so nobody has to hold them in their head. Leave one blank until you have read it.

Asset Score gross floor area

Square feet, from the report's structures and systems ratings.

Audit Template gross floor area

Square feet, for the same property.

Year built

Needed to read a Poor rating: before 1985 it is allowed.

Ratings evaluation

Heating set point

Degrees Fahrenheit. The standard is 68°.

Cooling set point

Degrees Fahrenheit. The standard is 76°.

Where the set points came from

Water heater energy factor (EF)

Window-to-wall ratio

Per cent.

Approve

Tick each check once you have confirmed it on the application. Save keeps your ticks so you can come back; Approve needs every box ticked.

Application review

Contractor and account contact details are on the application.
The income level is taken from the property's qualification.
Read below, never typed in: low, moderate, or market rate when the property has no qualification at all.
The proposed scope lists eligible measures, each with its own cost, and a project total.
A subcontractor's invoice is submitted for any work a subcontractor is doing.
Not applicable when no subcontractor is on the project.
Every required DOE field on the application is filled in from what the contractor sent.
The incentive or rebate amount lines up with the allocated percentage.
The SPECTRUM account and application numbers are recorded on the application, so the contractor dashboard shows them.

Contractor eligibility

Checked in Atlas, under the contractor account.
Checked in SPECTRUM: the contractor account and its timeline.
The contractor is registered and active.
The contractor is eligible for the measures they are installing.

Asset Score report (whole property)

Spot-checked square footage, property type, floor area and year built against the Audit Template.
Reviewed the estimated annual site energy savings.
The three reports behind a heat pump's modeled savings are on file.
The procedure's work-around for a measure the software cannot model: a primary model, a second run as though the property already had the improvement, and the calculator those two are entered into as Pre and Post against the conditioned floor area. What it produces is written onto the application and the Asset Score, so a savings figure with no reports behind it is what this catches.

Not required The procedure's modeling work-around applies only where the application includes heat pumps for space heating and cooling. This one lists none.
Standard occupancy and operating conditions give the number of occupants and the hours of operation.
Heating and cooling set points are within the standard.
68°F heating and 76°F cooling, and up to 5° either way is allowed. Set points from the Building Asset Tool or the Quick Building Asset Tool are not adjustable and are accepted as they are.
Every selected upgrade opportunity is eligible under the program.
Gross floor area agrees between the summary page and the structures and systems ratings.
The ratings evaluation lets the project go on.
Superior, Good or Fair clears it. Poor needs the property's age: built before 1985 it may continue, built 1985 or later it does not.
Checked the characteristics summary for inconsistencies.

Audit Template report (individual units)

Contractor and account name, address and contact details are confirmed.
The date of completion audit 1 matches the assessment completion date on the application.
Equipment usage, efficiencies and specifications match the Asset Score.
Energy usage is present.
Not applicable for a property of 5 or more homes that are individually metered. Under 5 individually metered homes are usually modeled in SnuggPro or Optimizer -- review against the HOMES modeling guidance.

Proposal

Contractor and account name, address and contact details are confirmed.
The description of improvements matches the Asset Score and the application.
The proposal meets program requirements.
Every measure's cost is evaluated.
HVAC and water measures must each carry a per-unit cost, the number of units, and the expected model number.

Submission

The finalized application, the processing notes and any exceptions sent are uploaded to the SPECTRUM application.
SPECTRUM is updated and processing continues per the HOMES Multifamily Custom App Procedure.
The offer letter is created, and sent to the contractor once the application is pre-approved.

These checks come from HOMES - MF - Intake and Qualifying Procedures, from IRA_RnD focus_reference_docs at 88a1ceb, revision 2026-09-18.

Energy model file (HPXML)

No HPXML file uploaded with this application.

Email

Incomplete application Application closing General notification

From: irahomes@focusonenergy.com
Delivered to: matt@openwatt.io (this is test: nothing reaches an applicant, a contractor or a colleague)

Subject

Message

Deny

Send back for more information

Assign

Control Center has no application called IRA PI/PA Portal (409), so it cannot say who has access to this portal. This list shows the people who have used this portal.

Assigned to

Comment — optional. Emailed to the person it is assigned to.

Timeline

Nothing has happened to this application yet.